Panel Saws > Panel Saw - CNC

SCM Sigma 65 Beam Saw W/ Dust Collection & Lift Table

MA ID: PNC-12195
Price: $15,000.00 -or- as low as $303.15/mo.*
General Location: Midwest
Category:

Panel Saw - CNC

Panel Saws

Manufacturer: SCM (SCMI)
Model: Sigma 65 Beam Saw
Year of Manufacture: 2001
Condition: Excellent

SCM SIGMA 65 BEAM SAW with Dust Collection and front lift table MAKE OFFER!! This panel saw was manufactured in April 2001, has a new control, and a new PLC. All parts are factory authorized and purchased through SCM parts. A new carriage drive chain was installed about 2 years ago. This saw has run an average of about 1 hour per day. Runs like new. Comes complete with KUFU Seco 10Hp dust collector. Kufu motor have been recently serviced and had bearings replaced. Lift table has 4000 lbs lift capacity. This is the cleanest Sigma 65 you will ever see on the used market. TECHNICAL SPECIFICATIONS Main motor 10hp Cut length 10’ 6” Cut height 2.25” 230 – 440 v 60 hz 3 5ft. air tables / one with fixed fence. 6 gripper clamps that are adjustable 2 carriage feed speeds Full rear protection wall. THK guides on rise and fall of blades Side alignment “Cutty” on board optimization software 3 sets of blades One 4,000lb lift table on the front included

Rigger: Not Required
All Information including Photos and Videos are supplied by a 3rd party Source.
Please confirm all data before committing to a purchase.
*Subject to credit approval. Additional programs available.