Saws > Cutoff/Miter/Toe Notchers

Wegoma SD16 CM Compound Double Miter Saw

MA ID: SCM-12735
Price: $19,500.00 -or- as low as $394.09/mo.*
General Location: Midwest
Category:

Cutoff/Miter/Toe Notchers

Manufacturer: Other manufacturer
Model: SD16
Condition: Very Good
Electric 480 volt, 60 cycle, 3 phase
Hours on meter: N/A

Features:

  • Serial #016 0004
  • Manufactured 07/28/2000
  • Maximum Cut Length: 213.5”
  • Minimum Cut Length: 25.5”
  • 5” H x 6.25” W cut capacity
  • 400MM (16 ½”) Saw Blades
  • 30mm Arbor
  • 480 Volt 3 Phase 60 Hz 9.3 Amps
  • 2 @ 2.64 kW (3.5 HP) motors
  • Fixed left head
  • Moveable right head with powered movement
  • Manual fine tune positioning of right head
  • Manual Length position lock
  • Constant zero point
  • Electronic digital length readout (0.001”)
  • Imperial lineal scale
  • Manual Miter +/-45° both heads
  • Electronic angle digital readout both heads (0.01°)
  • Indexing stops
  • Infinite angle manual lock
  • Manual compound miter, 45° out
  • Pneumatic saw head movement
  • Hydro-check pneumatic control of each head for smooth, controlled cut
  • Swing arm mounted controls
  • Two hand, maintain contact, anti-tie down actuation of saw heads
  • E-Stop button on control panel
  • Individual motor start controls

 

 

  • Each head equipped with left and right vertical and horizontal pneumatic hold down clamps
  • Independent operation of saw heads
  • Low air pressure safety switch
  • Air filter/regulator/lubricator
  • Minimum and maximum overtravel stop switches
  • Each saw head has a 3 ½” OD chip/dust port
  • Two center material work supports
  • Leveling feet

 

 

Condition:

  • Good condition
  • Completely cleaned and checked
  • Pneumatic lines replaced as needed
  • Pneumatic pilot check valves replaced as needed
  • Pneumatic manifold blocks installed
  • Saw bed inserts replaced
  • Horizontal clamp pads replaced
  • Control voltage hardwired and control box refurbished
  • Electrical conduit replaced as needed
  • Existing sawblades included
  • Current replacement cost, over $44,000
Rigger: Not Required
All Information including Photos and Videos are supplied by a 3rd party Source.
Please confirm all data before committing to a purchase.
*Subject to credit approval. Additional programs available.