Features: - Serial #016 0004
- Manufactured 07/28/2000
- Maximum Cut Length: 213.5”
- Minimum Cut Length: 25.5”
- 5” H x 6.25” W cut capacity
- 400MM (16 ½”) Saw Blades
- 30mm Arbor
- 480 Volt 3 Phase 60 Hz 9.3 Amps
- 2 @ 2.64 kW (3.5 HP) motors
- Fixed left head
- Moveable right head with powered movement
- Manual fine tune positioning of right head
- Manual Length position lock
- Constant zero point
- Electronic digital length readout (0.001”)
- Imperial lineal scale
- Manual Miter +/-45° both heads
- Electronic angle digital readout both heads (0.01°)
- Indexing stops
- Infinite angle manual lock
- Manual compound miter, 45° out
- Pneumatic saw head movement
- Hydro-check pneumatic control of each head for smooth, controlled cut
- Swing arm mounted controls
- Two hand, maintain contact, anti-tie down actuation of saw heads
- E-Stop button on control panel
- Individual motor start controls
- Each head equipped with left and right vertical and horizontal pneumatic hold down clamps
- Independent operation of saw heads
- Low air pressure safety switch
- Air filter/regulator/lubricator
- Minimum and maximum overtravel stop switches
- Each saw head has a 3 ½” OD chip/dust port
- Two center material work supports
- Leveling feet
Condition: - Very good condition
- Completely cleaned and checked
- Pneumatic lines replaced as needed
- Pneumatic pilot check valves replaced as needed
- Pneumatic manifold blocks installed
- Saw bed inserts replaced
- Horizontal clamp pads replaced
- Control voltage hardwired and control box refurbished
- Electrical conduit replaced as needed
- Existing sawblades included
- Current replacement cost, over $44,000
|