RUVO Door Factory Machine (Complete System for Entry Doors)
MA ID: | DSS - 3889 |
Status: | Sold |
Price: | Call For Price |
Category: |
Door & Stair ShapersDoor Clamps |
Manufacturer: | Ruvo |
Model: | 405, 512, & 1580 |
Condition: | Good |
COMPLETE SYSTEM INCLUDES : * RUVO 405 HINGE MACHINE * 512 STRIKE JAMB MACHINE + CLAMPS * 1580 SPIN/TILT TABLE
1.) The RUVO 405 Hinge Jamb & Door Mortising Machine is used to mortise the door & hinge jamb for hinge preparation. The 405 will mortise for two, three, or four hinges up to a 9' door & jamb. The 405 will work on split or flat jambs with or without applied stops. The door & hinge jamb is clamped in place, the first hinge position is routed automatically & the machine advances the higne jamb & door to the next preset hinge locations. The machine operator will then fasten the first hinge while the RUVO 405 automatically mortises the 2nd hinge position. The setup of the hinge position is accommodated by using stop bar to set for 6'8" to 9'0" doors & jambs.
Specifications : * Jamb Sizes : 6'6" to 9'0" Long 4-9/16" to 10" Wide * Hinge Sizes : 3-1/2", 4", 4-1/2", 5" (5/8" Radius) 3-1/2", 4", 4-1/2", 5" (1/4" Radius) * Door Thickness : 1-3/8" to 1-3/4"
2.) The RUVO Model 512 prepares the strike mortise in the strike jamb. This is a companion machine designed to complement the RUVO 405 or 505 pre-hung Door Machine.
Specifications :
3.) The RUVO 1580 Spin Tilt Table allows one operator to apply casing or brick mold to one or both sides of the pre-hung door units. It allows the operator to freely spin the door unit around & then with a push of a lever, the door unit can be tilted in either direction top or bottom.
Specifications :
|
Please confirm all data before committing to a purchase.
*Subject to credit approval. Additional programs available.